1. During the use of electric roller shutter doors, it is necessary to maintain the stability of the controller and voltage as much as possible. It is prohibited to install them in very humid environments. In addition, do not open the remote control arbitrarily. If any wires or knots are found on the door body, they should be dealt with in a timely manner. Pay attention to whether the channel is blocked, which hinders the door body from descending. If there is an abnormal response, immediately stop the motor operation.

2、要經常性的檢查電動卷簾門上下行程的開關，對行程控制器加上潤滑油，保持正常良好的運行，另外，操作人員手動控卷簾門，檢查器運行情況，校對上下行程開關位置，使電動卷簾門開啟或關閉時處于適當位置，且檢查過程中嚴防電動卷簾門沖頂或沖底或者反轉，如若出現緊急情況應立即停止轉動，切斷電源。

2. Regularly check the up and down travel switches of the electric roller shutter door, apply lubricating oil to the travel controller to maintain normal and good operation. In addition, the operator manually controls the roller shutter door, checks the operation of the device, and calibrates the up and down travel switch positions to ensure that the electric roller shutter door is in the appropriate position when opened or closed. During the inspection process, strictly prevent the electric roller shutter door from hitting the top, bottom, or reversing, If an emergency occurs, immediately stop rotating and cut off the power supply.

電動卷簾門安裝方法是什么 電動卷簾門有什么安裝方法

What is the installation method for electric roller shutter doors? What are the installation methods for electric roller shutter doors

3、操作員是經常性的要檢查好電動卷簾門的手動開關和手動升降裝飾，以防止在緊急的情況下電動卷簾門會失靈，或者造成不必要的事故。

3. It is best for operators to regularly check the manual switch and manual lifting decoration of the electric roller shutter door to prevent it from malfunctioning or causing unnecessary safety accidents in emergency situations.

4、要保持軌道運行暢通，及時清理電動卷簾門的軌道，保持內部清潔，卷簾門電機和傳動鏈條要經常加注潤滑劑，檢查控制箱內器件和開關控制盒，緊固接線端口，緊固螺絲等，清潔控制箱內、表面和按鈕上的灰塵污物，防止按鈕卡住而不能反彈。

4. To maintain smooth operation of the track, clean the track of the electric roller shutter door in a timely manner and maintain internal cleanliness. The motor and transmission chain of the roller shutter door should be regularly lubricated, and the components and switch control box inside the control box should be checked. Wiring ports should be tightened, screws should be tightened, and dust and dirt on the control box, surface, and buttons should be cleaned to prevent buttons from getting stuck and not rebounding.