自動玻璃門的使用在目前生活中是非常多見的，無論是家用或者是公司企業，我們都會看到它的身影，但是使用自動玻璃門以后，發現難免會出現一些故障，比如說不自動回原，那么就會影響玻璃門的使用，所以在對其進行安裝的時候，一定要多加注意細節。下面濟南電動卷簾門安裝維修廠家為您講解：

The use of automatic glass doors is very common in current life, whether it is household or corporate, we will see its presence. However, after using automatic glass doors, it is inevitable that some faults will occur, such as not automatically returning to the original position, which will affect the use of glass doors. Therefore, when installing them, it is necessary to pay more attention to details. Below, the installation and maintenance manufacturer of Jinan electric roller shutter doors will explain to you:

自動玻璃門安裝要上下門軸必須在一個垂線上，玻璃門必須采用鋼結構的橫梁做骨架，上軸必須焊接在橫梁上，因?yàn)樯祥T軸是整個玻璃門的支撐點，必須要牢固，禁止采用上部橫梁采用細木板木龍骨結構，因?yàn)樯祥T軸與木制作結構連接點只能使用自攻螺絲固定連接，由于開門次數多，時間長了使上門軸容易脫落，造成危險。

For the installation of automatic glass door, the upper and lower door shafts must be on the same vertical line. The glass door must use the steel structure beam as the skeleton, and the upper shaft must be welded on the beam. Because the upper shaft is the support point of the entire glass door, it must be firm. It is prohibited to use the fine wood board keel structure for the upper beam. Because the connection point between the upper shaft and the wood structural join can only use self tapping screws to fix the connection. Because of the large number of door opening times, Over time, the door shaft is prone to detachment, causing danger.

自動玻璃門安裝預埋地彈簧時要在原地面剔鑿一個長方形方坑，四周要大于地彈簧底座的10毫米，用于塞實高標號水泥砂漿，起到牢固的作用，建議地彈簧水泥凝固48小時后按照玻璃門，安裝好玻璃門地邊要距地8-12毫米，預防玻璃門在下垂的時候摩擦地面。

When installing the pre embedded ground spring for automatic glass doors, a rectangular square pit should be chiseled on the original ground surface, with the surrounding area being 10mm larger than the base of the ground spring. It is recommended to use the high grade cement mortar to fill it firmly. After 48 hours of cement solidification for the ground spring, it is recommended to install the glass door according to the glass door. The ground edge of the glass door should be 8-12mm away from the ground to prevent the glass door from rubbing against the ground when sagging.

地彈門的上下門軸要座于門框的中心，使自動玻璃門安裝好以后也能座于門框的中心，起到美觀的效果。安裝好玻璃上門邊要距橫梁3-6毫米，預防門下垂時上門軸和門夾的連接件不于脫離，還有一個細節問題要注意，門軸與門夾的部位要注入黃油，可以減少連接件的磨損，以延長使用壽命。

The upper and lower door shafts of the floor spring door should be located in the center of the door frame, so that the automatic glass door can also be located in the center of the door frame after installation, achieving a beautiful effect. After installing the glass door, it should be 3-6 millimeters away from the crossbeam to prevent the connection between the door shaft and the door clamp from detaching when the door sags. There is also a detail to note that butter should be injected into the position between the door shaft and the door clamp to reduce wear on the connection and extend its service life.

玻璃門的金屬配件，比如拉手、門邊金屬條等，如果脫落或者損壞直接替換即可。如果是地彈簧出現問題，建議請玻璃門維修師傅上門。

Metal accessories for glass doors, such as handles and door edge metal strips, can be replaced directly if they come off or are damaged. If there is a problem with the floor spring, it is recommended to have a professional glass door repairman come to your doorstep.

玻璃是很脆弱的，而且是極難修復的，一直以來流傳的這個成語“破鏡難圓”就說明了玻璃是會破碎的，而且想實現其的修復基本是不可能的。而且在加之現在玻璃門的使用越來越廣，在長期使用玻璃門的過程中，總會出現一些或大或小的故障，這些故障會影響玻璃門整體的使用效果。因此，遇到故障要及時處理，可以盡量的延長玻璃門的使用壽命。

Glass is very fragile and extremely difficult to repair. The idiom "broken mirror is difficult to round" that has been circulating in China indicates that glass can break and its repair is basically impossible. Moreover, with the increasing use of glass doors, there will always be some major or minor malfunctions during long-term use, which will affect the overall effectiveness of glass doors. Therefore, when encountering faults, it is necessary to handle them in a timely manner to extend the service life of the glass door as much as possible.

如果玻璃門在使用衡中出現不能正常滑動的現象，就要檢查其滑槽內是不是有雜質使其不能正常滑動，如果是，把滑槽內的雜質清理出來即可，看其能否正?；瑒?dòng)。如果不行，就檢查滑槽是不是生銹了。這種情況下，往滑槽內添加一些潤滑劑、潤滑油類的東西或者是對滑槽除銹。

If the glass door fails to slide normally during use, it is necessary to check if there are impurities in the sliding groove that prevent it from sliding normally. If so, clean the impurities in the sliding groove to see if it can slide normally. If not, check if the chute is rusted. In this case, add some lubricants or lubricants to the chute or remove rust from the chute.

玻璃門在我們生活中使用還是比較廣泛的，主要是美觀，使用方便，但是使用也會相對于脆弱。所以在使用我們中我們需要小心呵護，出現問題的話需要及時維修，更多相關內容就來我們網站http://luoboyy.com咨詢吧！

Glass doors are widely used in our daily lives, mainly for their beauty and convenience, but they can also be relatively fragile to use. So when using us, we need to be careful and take care of it. If there are any problems, we need to repair them in a timely manner. For more related content, please visit our website http://luoboyy.com Consult!