隨著很多大城市的不斷發展，購買電動卷簾門的人們越來越多，對卷簾門的需求也日益增長，但是物品也是就有壞的時候，那怎么樣去維修電動卷簾門，注意的地方是什么，濟南電動卷簾門安裝維修廠家特意了解到了一些保護電動卷簾門的方法，分享給大家。

With the continuous development of many large cities, more and more people buy electric roller shutter doors, and the demand for roller shutter doors is also growing. However, there are times when the goods are broken. How to repair the electric roller shutter doors? What should be paid attention to? Jinan electric roller shutter door installation and maintenance manufacturer specifically learned some methods to protect the electric roller shutter doors, and shared them with you.

1、電動機不動或轉速慢

1. The motor does not move or the speed is slow

故障原因：一般會出現以下幾種情況，線路斷路、還有電機燒損、或者按鈕沒復位、限位開關動作、負載較大等引起。

Fault cause: Generally, the following situations may occur, such as open circuit, motor burning, or button not reset, limit switch action, heavy load, etc.

處理方法：先要檢查電動卷簾門線路、并接通；更換電動卷簾門燒損電機；更換電動卷簾門按鈕或重復按動電動卷簾門幾次；撥動電動卷簾門限位開關滑塊使它脫離微動開關觸點，并調整開關位置；檢查機械有無卡阻，有則卡阻清理障礙物。

Treatment method: first check the electric shutter door circuit and connect it; Replace the burned motor of the electric shutter door; Replace the electric roller shutter button or repeatedly press the electric roller shutter several times; Move the limit switch slider of the electric roller shutter door to make it separate from the microswitch contact and adjust the switch position; Check whether the machine is blocked, and if it is, clear the obstacles.

2、控制失效

2. Control failure

看清楚電動卷簾門故障發生的部位及原因：繼電器觸點粘死、行程開關失效，或者是靠板的螺絲有松的現象使靠板移位，、限位器傳動齒輪破損、按鈕上、下鍵卡死。

See clearly the position and cause of the failure of the electric shutter door: the relay contact is stuck, the travel switch is invalid, or the screw of the backup plate is loose, which causes the backup plate to move, the transmission gear of the limiter is damaged, and the upper and lower keys of the button are stuck.

處理方法：更換電動卷簾門繼電器；換一下微動開關的或是觸片；緊定電動卷簾門滑塊螺釘讓靠板復位。

Handling method: replace the electric shutter door relay; Replace the microswitch or contact; Tighten the slide screw of the electric shutter door to reset the backup plate.

3、電機振動或噪聲較大

3. Motor vibration or noise is large

剎車盤有斷裂的情況；沒有緊固剎車盤；齒輪嚙合不順、失油或磨損嚴重；電機電流聲或振動。

The brake disc is broken; The brake disc is not fastened; Gear engagement is not smooth, oil loss or serious wear; Motor current sound or vibration.

處理方法：更換一下電動卷簾門剎車盤或重新調整平衡，然后緊固電動卷簾門剎車盤螺母；

Treatment method: replace the brake disc of the electric roller shutter door or readjust the balance, and then tighten the brake disc nut of the electric roller shutter door;

注意事項：

matters needing attention:

1、卷簾門在上下啟閉的時候查看清楚電動卷簾門上面是否堆物，普通的也需要注意，在操作的時候，同時人也需要在現場，看看情況，是不是有軌道卡位情況，這樣才不會給電機和門簾造成更大的傷害。

1. When the roller shutter door is opened and closed up and down, check whether there is any pile on the electric roller shutter door. Ordinary people also need to pay attention to it. During operation, people also need to be on the scene to see if there is track jam, so as not to cause greater damage to the motor and the door curtain.

2、門簾在開閉的同時，嚴禁行人在此處去奔跑，避免引起事故的發生。

2. When the door curtain is opened and closed, pedestrians are prohibited to run here to avoid accidents.

3、商家在選電動卷簾門方面也應該多考慮，使用輕便，電動卷簾門堅固耐用的材質，這樣即使在特殊情況下也能起到較高的問題。

3. Businessmen should also consider more about the selection of electric roller shutter doors. They should use light and durable materials for electric roller shutter doors, which can play a higher role even under special circumstances.

4、卷簾門電機的選購也是比較重要的一個環節，切記不要感覺電動卷簾門提升力夠用就行，電動卷簾門電機的承載力會慢慢的降低實際的提升功效。

4. The selection and purchase of the electric roller shutter door motor is also an important part. Remember not to feel that the lifting force of the electric roller shutter door is sufficient. The bearing capacity of the electric roller shutter door motor will slowly reduce the actual lifting efficiency.

很多人也會選擇，也是選擇電動卷簾門不可或缺的的因素，但是不清楚的商家會選擇低價位私人小作坊來制作，這是降低了成本，但是質量上根本沒辦法得到保障，還有維修也是如此。更多相關內容就來我們網站http://luoboyy.com進行咨詢！

Many people will also choose brands, which are also an indispensable factor in choosing electric roller shutter doors. However, it is not clear that businesses will choose low-price private workshops to make them, which reduces costs, but there is no way to guarantee quality, and so is maintenance. Come to our website for more relevant content http://luoboyy.com Consult!