卷簾門限位怎么調節

來源：http://luoboyy.com/  發布時間：2024-02-21 21:24:36

一、卷簾門限位怎么調節

1、 How to adjust the limit position of the rolling shutter door

松開限位上面的螺釘。其次把門的高度確定到實際位置。

Loosen the screw above the limit. Next, determine the height of the door to its actual position.

之后將門開合適方位，扭轉限位螺母讓它壓住上面的滾輪，發出“滴達”聲后，將螺釘旋緊。

Afterwards, open the door to the appropriate position, twist the limit nut to press it against the roller on top, make a beep sound, and then tighten the screw.

后將門關合適方位，扭轉限位螺母讓它壓住上面的滾輪，發出“滴達”聲后，將螺釘旋緊就行了。

Close the door to the appropriate position, twist the limit nut to press it against the roller on top, make a beep sound, and then tighten the screw.

二、電動卷簾門怎么保養

2、 How to maintain electric roller shutter doors

1、在使用卷簾門的時候，應當保持控制器和電壓的平穩，不可以們把它將其裝置在有水的環境里，同時也別隨便的開啟遙控器。如果在使用的時候出現門體上有電線纏繞等問題，一定要馬上處理掉。

1. When using a rolling shutter door, the controller and voltage should be kept stable. It is not allowed to install it in a water environment, and the remote control should not be opened casually. If there are problems such as tangled wires on the door body during use, it must be dealt with immediately.

2、卷簾門應按時對做好檢查，查看它上下行程開關有沒有順暢，對控制器要按時涂潤滑油，讓它維持正常良好的運行。此外，在查看卷簾門運轉狀態時，要校正上下行程開關的位置，檢查有沒有錯位的問題發生，讓它在開關的時候處于適合的位置上，如果發生緊急情況，則一定要立即暫停轉動，同時關掉電源。

2. The rolling shutter door should be inspected on time to check if its up and down travel switches are smooth. The controller should be lubricated on time to maintain normal and good operation. In addition, when checking the operation status of the roller shutter door, it is necessary to correct the position of the up and down travel switches, check for any misalignment issues, and ensure that it is in the appropriate position when opening and closing. If an emergency occurs, it is necessary to immediately pause the rotation and turn off the power.

3、此外，卷簾門運行時應保持軌道的通暢，如果軌道里面存在雜物，則一定要馬上清潔掉，保持里面干凈。還有，應對里面電機和轉動的鏈條上潤滑劑，同時查看它的內器件和開關控制盒

3. In addition, the track of the rolling shutter door should be kept unobstructed during operation. If there are debris inside the track, it must be cleaned immediately to keep it clean inside. Also, deal with the lubricant on the motor and rotating chain inside, and check its internal components and switch control box at the same time

本文由濟南電動卷簾門安裝維修友情奉獻.更多有關的知識請點擊:http://luoboyy.com真誠的態度.為您提供為的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待

This article is dedicated to the installation and maintenance of Jinan electric roller shutter doors. For more information, please click: http://luoboyy.com Sincere attitude. We will provide you with comprehensive services. We will gradually contribute more relevant knowledge to everyone. Stay tuned