在安裝電動卷簾門需要注意的事項你知道有什么嗎？如下濟南電動卷簾門安裝維修人員為您介紹一下在安裝電動卷簾門的時候需注意的幾個要點：

Do you know what to pay attention to when installing the electric roller shutter door? The installation and maintenance personnel of Jinan electric roller shutter door will introduce some key points for you to pay attention to when installing the electric roller shutter door:

1、復核洞口與產品尺寸是否相符,防火卷簾門的洞口尺寸,可根據3M。

1. Check whether the hole size is consistent with the product size, and the hole size of the fire shutter door can be based on 3M.

2、確定安裝水平線及垂直線，按設定尺寸依次安裝.槽口尺寸應準確，上下保持一致，對應槽口應在同一平面內，然后用連接件與洞口內的預埋件焊牢。

2. Determine the installation horizontal line and vertical line, and install them in sequence according to the set size. The notch size should be accurate, consistent from top to bottom, and the corresponding notch should be in the same plane, and then use the connector to weld firmly with the embedded parts in the hole.

3、卷門機必須按說明書要求安裝。

3. The door roller must be installed according to the instructions.

4、卷軸、文架板必須牢固地裝在混凝土結構上或預埋件上。

4. The reel and document shelf plate must be firmly installed on the concrete structure or embedded parts.

5、寬大門體需在中間位置加裝中柱，兩邊有滑道.中柱安裝必須與地面垂直，安裝牢固,但要拆裝方便。

5. The wide door body needs to be installed with a central pillar in the middle, with a slide on both sides. The central pillar must be installed vertically with the ground and firmly, but it should be easy to disassemble.

6、門體葉片插入滑道不得少于30mm，門體寬度偏差為土3mm。

6. The gate blade shall be inserted into the slide at least 30mm, and the gate width deviation shall be 3mm.

7、防火卷簾門水幕系統裝在防護理下面,噴嘴傾斜15°角。

7. The water curtain system of the fireproof rolling shutter door is installed under the anti-care, and the nozzle is inclined at an angle of 15 °.

8、安裝完略,先手動調'自試運行，觀察門體上下運行情況，正常后通電調試。

8. After installation, first manually adjust the self-test run, observe the operation of the door body up and down, and then power on the commissioning after it is normal.

9、觀察卷簾機、傳動系統、門體運行情況應啟閉正常、順暢,速度為3-7米/分鐘。

9. Observe the operation of the roller shutter, transmission system and door body. The opening and closing shall be normal and smooth, and the speed shall be 3-7 m/min.

10、調整制動器外殼方向，使環形鏈朝下;調整鏈條張緊度，鏈條6-10mm;調整單向調節器及限位器。

10. Adjust the direction of the brake housing so that the annular chain is downward; Adjust the chain tension, the chain is 6-10mm; Adjust the one-way regulator and limiter.

11、卷筒安裝應先找好尺寸，并使卷簡軸保持水平位置。注意與導軌之間的距離應兩端保將一致，臨時固定后進行檢查,并進行必要的調篷、校正,無誤后再與支架預埋件用電焊焊接。

11. When installing the drum, first find the size and keep the winding shaft in a horizontal position. Note that the distance between the guide rail and the guide rail should be the same at both ends. After temporary fixing, check it, adjust and correct it, and then weld it with the embedded parts of the support by electric welding.

12、清理、粉刷或鑲砌導軌墻體裝飾面層，清理現場。

12. Clean, paint or inlay the decorative surface of the guide rail wall, and clean the site.

在安裝電動卷簾門時需注意的要點就講解完畢了，感謝您的閱讀，希望給您好的幫助，更多使用事項就來我們網站http://luoboyy.com咨詢了解吧！

The key points to pay attention to when installing the electric roller shutter door are explained. Thank you for your reading and hope to give you good help. Please come to our website for more usage matters http://luoboyy.com Ask about it!